I have a doubt about configuring and using neXt...
Should I use a completely CLEAN memory on my transmitter and make all the adjustments in the software? Or should I use the REAL memory (that I use on my real helicopter) for getting in the software all my adjustments?
Yes, you should use a clean model in your transmitter. It's best to use a fixed-wing preset here.
Just configure your two sticks in Settings > Input Device. It is recommended to configure only the autorotation switch in the Settings > Input Device > Features tab. You should not assign a throttle channel and the flight conditions are usually not needed in a sim.
Hi Klaus, Would you have any knowledge on this question as I’ve just purchased the next sim, the blades are spinning with no throttle input is this correct? I’ve tried reducing the rpm in the settings which results in very little or no lift. I’ve tried loading fixed wing and the throttle response is correct so I’m wondering if that’s the way it’s supposed to be with the helicopter.
Why should it? In reality, you use an ESC to hold the rpm, and the motor doesn't stop until you activate autorotation in your transmitter.
You are not using a throttle curve. And if you really need a throttle curve, you can assign it under Settings > Input device > Functions. But remember ... this is not the recommended way to use it here.
