FAQ » Connection issue Spektrum DX6i transmitter with Next simulator

Fri Mar 30, 2018 10:41 am

Pjotr
#1

Pj

Hello,

I've purchased the Next software package with the RX2SIM adapter but I'm not able to connect my Spektrum DX6i transmitter.

I've attached two pictures which show the hardware setup.
The receiver is the Spektrum AR610 which is connected to the transmitter.
When I try to start the calibration the Next software doesn't recognize the transmitter.

My main question is: how can I connect my Spektrum transmitter to the Next software?

My sub questions which might help solving the issue:
Which mode should I use on the RX2SIM adapter?
Should I use the 3 wire patch cable or the 7 wire patch cable? In which channel should I connect the patch cable on the reciever?
The transmitter doesn't start in trainer mode. It only starts in trainer mode if I plug in a micro-jack cable.
Do I need a Simulator Interface Dongle?

Kind regards,
Pjotr

reply

Report post

#2

Sat Mar 31, 2018 11:54 am (Last edited: Fri Jan 24, 2020 9:20 am)

Klaus-Eiperle
#2

Klaus-Eiperle

Hello,

your mode led is green. That's wrong. The output mode led should be purple. Simply switch to purple by pressing the black know for a short time.

You don't need any further hardware and of course, your transmitter is not in trainer mode while you are using an wireless solution.

So, I would connect the 3pole patch cable into one transmitter output channel and the other part should be connected like shown in this photo, section rx2sim:
https://www.cgm-online.com/rc-flight-sim...next-usb_e.html

Of course, then the input mode of the rx2sim should be set to single channels.

All the best,
Klaus

Align T-Rex 700X, Goblin Black Thunder T Line 710, MR25, Katana S 33%

reply

Report post

#3

Tue Apr 03, 2018 9:37 pm

Pjotr
#3

Pj

Pjotr

Hello,

Thanks for the reply and explanation. I managed to connect and calibrate the Spekrum transmitter. Now it works very smooth :-)

Kind regards,
Pjotr

reply

Report post