Bonjour, vous expliqué qu'il faut d'abord créer un nouveau modèle à voilure fixe dans votre émetteur. Je suis débutant pourriez vous m'expliquer. J'ai brancher le récepteur Spektrum AR620 sur le RX2Sim comme vous laver expliquer mais le voyant bleu clignote. Comment puis-je connecter mon émetteur au RX2SIM. Cordialement Falco
I've purchased the Next software package with the RX2SIM adapter but I'm not able to connect my Spektrum DX6i transmitter.
I've attached two pictures which show the hardware setup. The receiver is the Spektrum AR610 which is connected to the transmitter. When I try to start the calibration the Next software doesn't recognize the transmitter.
My main question is: how can I connect my Spektrum transmitter to the Next software?
My sub questions which might help solving the issue: Which mode should I use on the RX2SIM adapter? Should I use the 3 wire patch cable or the 7 wire patch cable? In which channel should I connect the patch cable on the reciever? The transmitter doesn't start in trainer mode. It only starts in trainer mode if I plug in a micro-jack cable. Do I need a Simulator Interface Dongle?
Use the three-core cable and connect it to the RX2SIM at - + 1 and the other end to channel 1 on your AR620. The orange wire should be facing up. Then plug the other cable with the many wires into the RX2SIM (2 to 8) and 5 of the wires on the AR620 on channels 2, 3, 4, 5 and 6. Orange again on top.
Switch the RX2SIM to purple mode and the input mode should be single channel. If the blue LED is not flashing, you have a valid signal from your transmitter. Of course, you should bind your receiver to your transmitter beforehand. Make sure that your receiver indicates that it is receiving a valid signal from your transmitter.
Then you go to Settings > Input Device in the simulator and calibrate. Follow the instructions there.
